Pet Toy Toggle HDPE Blow Molding Machine 200ml Fully Automatic

HDPE High Speed 1 Layer Automatic Extrusion Blow Molding Machine for Plastic Pet Toys

SLBU series:

1: this machine is suitable for the production of 200ML 10L plastic hollow products, the use of curved elbow lock system, low energy consumption, the center of the lock, the lock force, speedF aster, run more smoothly,with MOOG parison system100 points.

2: die opening and closing system: specially designed for Heng lock mould mechanism using a high pressure mode locking, locking plate stress in the centre of the template, clamping force, openThe rigid lock template, even if the ultra wide die is also fitted. 

3.The temperature control is not accurate or the temperature deviation is large, and the installation position of the temperature measurement point(thermocouple) is unreasonable, which causes the temperature to produce periodic deviation. With the increase of the temperature deviation, the deviation affecting the weight also increases. When the temperature rises, the extrusion tube is stretched and increased. In the same operating cycle, the water mouth material on the bottom of the bottle is increased and the product weight is reduced. When the temperature is low, the weight of the product increases. When the thermocouple has poor contact, there is a similar failure. If the thermocouple is bad, the extrusion amount decreases, and when it is lower than the temperature of the plastic melting point, the motor current increases.