6 Layer HDPE Toy Blow Moulding Machine 5l Automatic Molding

HDPE Double Station Extrusion Blow Molding Machine for Plastic Ice-cream Toys.

SLBU series:

1. Before production, check whether each moving part is firm and whether the screws loosen and fall off, especially if the impact force is strong, and whether the belt drive part is abnormal.

2. Check the warming head into the embryo, part of the work out of the embryo is normal. Insert the embryo if not in place to adjust the embossing device nut.

3. When starting the machine, the motor must be started and the heating machine must be delayed for 30 seconds to prevent voltage fluctuations. Before starting warming, make sure that the cooling water is not turned on.

4. After the warm-up starts (2-3 minutes), wait until the oven temperature rises evenly and press the embryo button. At the same time, the bottle blowing power must also be turned on, otherwise it will not blow the bottle.

5. Check if the lamp is damaged or broken. Replace it in time.

6: this machine is suitable for the production of 200ML 10L plastic hollow products, the use of curved elbow lock system, low energy consumption, the center of the lock, the lock force, speed faster, run more smoothly.