60l Accumulator Blow Moulding Machine Cleaning Tools , 450bph Fully Automatic Blowing Machine

1 Die Head Accmulator Type Single Station Plastic Blow Molding Machine For Plastic Cleaning Tools​

SLBC series: (German model)  linear guide support single frame, finite element analysis of the design, to ensure adequate clamping force, not up

mode.

   In the adjustment and debugging, the gap between the blow head slit and the die cut is adjusted by the adjusting nut on the blow pin cylinder; the

   front and rear concentricity between the blow head cut and the die cut is through the needle holder and the blow Three M12 screws on the fixing

    plate of the device are used to adjust the large offset amount. The left and right concentricity between the blow head slit and the die slit is

    adjusted by the M12 screw on the needle holder and the fixed plate to adjust the large offset amount. The amount is adjusted by three M6

    screws on the mounting plate. The guide column and the air blowing rod on the air blowing device must be refueled from time to time to make it   

    work normally.